Skoda Fabia 2014-2018 Complete Single Din Facia Kit ACV 611340-09-01

This complete Single Din Radio Replacement Kit by Connects2 allows the fitment of a Single-DIN aftermarket headunit to the selected vehicle. The kit includes everything you need to complete the installation including fascia, wiring harness, and aerial connections.

Connects2 CTKSK07

• Single Din Fascia Adaptor
• ISO Wiring Harness
• Aerial Adaptor

Compatible with the following vehicles:

Not for vehicles:
with Most OEM amplified system
with open dash
without any OEM preparation > SWC / speakers / HU

vehicles with parking assistance front PDC > front PDC is shown after ignition in display
exit the display > acknowledge via vehicle PDC switch
vehicles with MIB II systems

Many car manufacturers install car specific head units to match the optic of the dashboard.

Installation kits include all components for replacing an OEM HU.

Depending on the vehicle's equipment, all adapters and interfaces required to operate the retrofit device and restore vehicle functions are included in the scope of delivery.

Please check the installation recommendations for the individual components.

In some cases, not all vehicle functions are supported.
For example, Trailer Assist, E Call or other driver assistance systems.

Please check the OEM HU and vehicle settings for available settings before installation.

Depending on the vehicle equipment as well as the range of functions and software of the retrofit HU, individual operating functions may be omitted or replaced by other functions.

Compare the pictured harness connectors with the connectors in your car and make sure that they fit optically and technically.

Also check if one of the listed OEM head units were installed originally.

Finally check vehicle functionality, vehicle settings and SWC functionality before final assembly.

Note: vehicles with SWC Can Bus connector: 52 Pin Quadlock VAG connector: OEM antenna Fakra(m)(double) > ISO(m) blue: +12V antenna remote call up menu settings > purple/white reverse signal output connected to the HU visualise menu settings > RCA(m) yellow connect to the rearview camera input and configure vehicle settings and vehicle information > mirrored on the retrofit monitor rear view camera input menu settings: mute button or speech button press 5 x depending on the vehicle equipment and software: not all vehicle settings are supported not all vehicle functions are supported not all vehicle information is visualised operate the CAR vehicle setting menu with the SWC keys

E-Call not supported

vehicles with E-Call:
E-Call function retention MAN/Seat/Skoda/VW 52 Pin Quadlock > item: 1424-02