Rockford Fosgate T1000X5AD - 1000W Power Series Bridgeable Class AD 5-channel Amplifier

Super-compact, bursting with power

Rockford Fosgate's Power Series T1000X5ad 5-channel amplifier can send 100 watts RMS each to four separate speakers while delivering up to 600 watts RMS to a subwoofer. Or you could use this tiny powerpack to run a couple of high-performance components with 200 watts each along with 600 watts RMS for the sub. A dual-fan forced air cooling system keeps this sturdy little amp from overheating, so it can play hard for a long time.

Class AD: accurate and powerful

Rockford Fosgate uses their proprietary Class AD amplifier technology, combining the high fidelity of a Class A system with the high efficiency of their special Class D technology, to bring you this ultra-efficient, high-output amplifier. In other words, this compact amp produces more power with less current draw from your vehicle's charging system than most other amps on the road today.

Rockford Fosgate's high-tech solutions yield more power

This Power Series amplifier actively monitors speaker and subwoofer performance, using Rockford Fosgate's Constant Power technology. A speaker's impedance naturally fluctuates as it performs, fighting against your amp's output. So, just like your cruise control increases the engine's RPM to maintain your car's speed uphill, Constant Power maintains this amp's output by increasing its internal voltage and current flow when the speaker's impedance rises. This results in up to a 25% increase in the amp's total power output.

T1000X5ad control panel with clip lights

Easy to set for optimum performance

Rockford Fosgate's C.L.E.A.N. technology (Calibrated Level Eliminates Audible Noise) setup system ensures your music will sound as clean and powerful as possible. It works like this: play the setup tone on the included test CD, adjust the receiver volume until a red clip light on the amp goes out, then turn the amp gain up until a blue light comes on. It's that simple — your amplifier will be perfectly set to match your receiver's output. When your receiver reaches maximum clean volume, you'll get maximum clean power from your power amp. At quiet listening levels, you'll hear less background noise and more of your music.

Clip lights monitor distortion

If that blue light turns solid red while you're playing music, the amp's telling you that your source is distorting and you should turn it down, or risk damage to your gear. The optional PLC2 remote level control also doubles as a clip indicator, so you can see from the front seat if your music's clipping and restore pristine sound.

Product Features:

• Rockford Fosgate Power Series T1000X5ad
• Class-AD Full Range 5-Channel Amplifier
  • Channels 1/2/3/4: Class-AD
  • Sub Channel: Class-BD
• Full Range RMS Power Rating:
  • 4 ohms: 100 watts x 4 chan.
  • 2 ohms: 100 watts x 4 chan.
  • 1 ohm: ------------N/A------------
  • Bridged, 4 ohms: 200 watts x 2 chan.
• Subwoofer RMS Power Rating:
  • 4 ohms: 400 watts x 1 chan.
  • 2 ohms: 600 watts x 1 chan.
  • 1 ohm: 600 watts x 1 chan.
• Total power output: 1000 watts
• CEA-2006 Compliant Amplifier
• Pulse Width Modulated MOSFET power supply
• LED power (green) and protect (red) indicators
• Soft start turn-on
• 5/4/3/2 or Mono channel operation
• Constant power technology
• Delivers instantaneous output power over varying impedance loads
• 25% increase in total amplifier power
• C.L.E.A.N. (Calibrated Level Eliminates Audible Noise
  • LED indicators identify both signal clipping and output level clipping
  • Eliminates speaker damage due to distortion
• 3-Stage Airflow ensure your amplifier runs cool and at optimal performance
• 3-way protection circuitry (thermal, overload, and speaker short protection)
• Dual extruded aluminum heat-sink for extreme heat dissipation
• Input sensitivity:
  • Low level: 150mV-12V
  • High level: 150mV-12V
• Frequency Response: 20 - 20,000 Hz
• Total Harmonic Distortion (THD): <1.0%
• Signal to Noise Ration: >80db (Full Range), >75db (Sub)
• Variable high-pass filter: 50 - 250 Hz, 12 dB/octave
• Variable low-pass filter: 50 - 250 Hz, 12 dB/octave
• Subsonic filter: 50 - 250 Hz, 12 dB/octave
• Fuse Rating: 100 A x 1
• Optional Punch Level Controller Sold Separately - PLC2
• 4 gauge power and ground wiring is recommended for installation. 
• Dimensions: 1.6"W x 4.3"L x 12"H
• Authorised Internet Dealer
• Full Manufacturer's Warranty

What's in the box: