Want to add your own speakers and amps to a factory system?
AudioControl's LC6i 6-channel line output converter (LOC) allows you to add aftermarket amps, speakers, and subs to your car's factory radio, so you can enjoy better and more powerful sound without losing climate controls, voice-activated functions, or other built-in factory features. The LC6i accepts speaker-level signals, so you can use it with just about any setup, even high-powered amplified systems.
Summing signals
The LC6i sums its input signals together, even if they've been crossed over for tweeters, mids, and subs by the factory system. That way, you can count on a strong, smooth, full-range signal for your processors and amps. The LC6i features six RCA preamp outputs that'll handle a traditional front/rear/sub setup.
Level-matching with an LED indicator
AudioControl makes it easy: set your factory stereo to about 3/4 maximum volume, turn the output level control of the LC6i until the "Maximized" light begins to flicker, then adjust the gain controls on your amps, and you're done. You've level-matched the output of your receiver to the amplifier's input, so you can count on getting maximum performance and minimum noise from your system.
Convenience
The optional dash-mounted ACR-1 wired remote allows you to adjust the volume of the bass while you're on the go. The speaker-level inputs sense incoming signals and turn on the LC6i, while a built-in 12-volt trigger turns on your amps as well. If your factory system only has channels for front and rear speakers, AutoMode™ will create the output you can use for your subs.
Product Features:
Speaker Input: 2CH
Outputs: 4CH
REM In: Yes
REM Out: Yes
Load Select: 10-Ohm / 60-Ohm / 20K-Ohm
Ground Isolation: GND/ISO/200-Ohm
Gain: Yes,X1
Clipping: Yes,X1
Center Frequency: 20Hz-110Hz
Bass Level: -9 ~ +9dB
Turn On Mode: REM/DC/AUDIO
Input Mode: 2CH
Remote: None
Dimensions: (LxWxH)mm 130.6x82x24.8mm
Chassis Body: Aluminum
Operating Voltage: 8 to 32V
Input Sensitivity: 0.5 to 32V
Output Voltage Max: 7.5V @ 14.4V
Max: 40V as Input Must be 20K-ohm load
Signal to Noise: >100dB @6.4V output
Input Impedance: 10-Ohm / 60-Ohm / 20K-Ohm
Frequency Response: 10-30kHz
THD+N: <0.01%
Output Impedance: <120-ohm
Max Current Draw: 120-150 mA
Turn-On Trigger: DC 3 to 7V
Gain: -28 to 0dB
Terminal Gauge: Quick Connect / 16# AWG
Price | £59.99 |
---|---|
Manufacturer | Phoenix Gold |
Vehicle Manufacturer | None |