Tune it in and turn it up
Built like a tank packed with sound-shaping capabilities and ready for action, Kicker's LX1300.7 multi-channel amplifier features customizable digital signal processing and high output power, so you'll experience high-quality enjoyment every time you listen to a song. The amp looks as good as it sounds, sporting adjustable RGB accent lighting and a slick reversible cover plate displaying the Kicker logo.
Fits in with factory systems
This LX-Series amplifier features Kicker's FIT+™ technology, which enables it to easily integrate into almost any factory stereo, and comes with high-level speaker wire input adapters to simplify installation. The amp's gain controls feature built-in clip lights, which aid in setting the gain properly.
RMS Power
The LX1300.7 has seven powered output channels designed to drive a couple of tweeters with 65 watts each, four mid- and full-range speakers with 125 watts each, and a subwoofer with up to 700 watts. You can also bridge the front and rear amp channel pairs together to power two high-performance drivers with 250 watts RMS each, and the tweeter channels together to power a center channel speaker with 130 watts, while still powering a sub with 700 watts.

LXCC DSP controller
LX Control Center digital processing
You won't need to use your laptop or phone or download any complicated DSP tuning app because the LX1300.7 comes with an LXCC plug-in control console for dialing in and displaying the channel settings, tones, frequencies, timing, and other digital signal processing data needed to create the perfect sound. Tuning options include selectable crossover types and slopes, channel level balancing and fine-tuning, and time delay for the left channels to match the right. There's also a KickEQ+™ parametric bass boost and phase control switch for the subwoofer channel.
Bass tuning and other remote features
After setup, you'll unplug the LXCC and plug in the amp's LXRC remote control. This wired remote controls the subwoofer level, and displays the system voltage, controls the amp's RGB brightness, and can add low-frequency content to bass-poor recordings using Kicker's SHOCwave2.0™ digital bass restoration algorithm.

LXRC bass knob
Specifications
- LX Series Class D 2-ohm Stable 7-Channel Amplifier
- RMS Power Rating:
- 4 ohm: 125 watts x 4 channel + 300 watts x 1 channel
- 2 ohm: 150 watts x 4 channel + 550 watts x 1 channel
- Bridged: 250 watts x 2 channel @ 4 ohm + 550 watts x 1 channel @ 2 ohm
- Amp 3 (stereo pair): 65 watts x 2 channel @ 4 ohm
- Amp 3 (stereo pair): 65 watts x 2 channel @ 2 ohm
- Amp 3 (stereo pair) Bridged: 130 watts x 1 channel @ 4 ohm
- Total power output: 1150 watts
- LED Power/Protect Light
- Wired bass level remote control included
- Speaker-level (high-level) inputs
- 1 pair of pre-amp outputs
- Signal sensing remote turn-on
- 3-way protection circuitry (thermal, overload, and speaker short protection)
- Incrementally dial in the entire system with the included LX Control Center
- Monitor and adjust sub sub-section with the included LXRC Dash Remote
- Customize the appearance with a reversible center panel and a choice of 11 RGB LED
- Equipped with FIT+ technology, accepting low- and high-level signals up to 40V
- Input sensitivity:
- Low level: 125mV - 5 volts
- High level: 1 - 40 volts
- Frequency Response: 20 - 20000 Hz
- Total Harmonic Distortion (THD): 1%
- Signal to Noise Ratio: >75 dB
- Variable high-pass filter: 20 - 5000 Hz
- Variable low-pass filter: 40 - 5000 Hz
- Subsonic filter: 10 - 80 Hz
- Variable Bass Boost: 0 - 6 dB
- Fuse Rating: 150A
- 1/0 AWG gauge amplifier wiring kit is recommended for installation
- UK Internet Dealer
- 1-year Manufacturer's Warranty
- MFR #: 51LX13007
LX Control Center (LXCC) Specifications:
- Monitor battery voltage, LED output clip indication, amp temperature, and protection status
- Adjust gain trim, left-channel time delay, and selectable crossover type, slope, and frequency
- Allows for both HP, LP or BP crossovers for all full-range channels
- 0-6dB with adjustable center frequency and Q for the sub channel
LX Remote Control (LXRC) Specifications:
- Dynamic fingertip dash remote of bass level adjustment
- Features SHOCwave2.0 (Sub-Harmonic Octave Creation)
- Recovers lost, low-bass frequencies vital to your music selections
- Displays battery voltage in a fuel-gauge-style readout
- Control of its RGB LED brightness
- Output clipping indicator to prevent distortion and protect your system
What's in the box:
- 7-Channel amplifier
- LXCC Control Center with attached 39" cord (terminated in an RJ-45 connector)
- LXRC Remote bass control with attached mounting bracket
- 19.5' Remote bass control cable (terminated in RJ-45 connectors on both ends)
- 10" Speaker-level input harness
- Four 1-3/8" screws
- Two 3/8" screws
- 3mm Allen key
- Owner's manual
- Power chart
- Power certificate
Price | £999.99 |
---|---|
Manufacturer | Kicker |
Vehicle Manufacturer | None |