Kicker 48PXA6001 600W RMS PXA Series Class-D Monoblock Marine Amplifier

Power your bass wherever you go

Kicker designed their PXA300.1 mono subwoofer amplifier so bikers, off-roaders, and boaters can enjoy clear, powerful bass over the noise of the motors, wind, and spray. And this amp is small enough to fit almost anywhere in whatever kind of vehicle you have, will keep playing even after a short dunking underwater, and will survive a good powerwash when the fun's over for the day. All the adjustment controls are inside the amp, protected from the elements, and only accessible by removing the water-tight operation panel cover from the bottom of the amp.

Power and tunability

The PXA300.1 can power a low-impedance 1-ohm subwoofer with up to 300 watts RMS. A fixed subsonic filter and a selectable low-pass filter customize the sound to fit your sub. Other controls include a bass boost to enhance low-end impact and an optional wired remote to control the bass from the driver's seat.

Product Features:

• PXA Series Class D 1 ohms Stable Monoblock Amplifier
• RMS Power Rating:
• Total RMS power output: 600 watts
• Dynamic Power (watts): 850
• LED Power/Protect Light
• Wired bass level remote control with optional 
• Speaker-level (high-level) inputs (Requires adapter like the)
• Signal sensing remote turn-on
• Protection circuitry
• Ideal for UTVs, off-road vehicles, hot rods or space-challenged vehicles
• Waterproof design with IP66/IP67 rating
• Includes inline power and ground couplers that need no soldering or crimping
• Input sensitivity:
• Frequency Response: 25 - 200 Hz
• Total Harmonic Distortion (THD): <1%
• Signal to Noise Ratio: 95 dB
• Selectable low-pass filter: 60, 80, 100, 120Hz at 12 dB/octave
• Subsonic filter: fixed at 25Hz
• Selectable Bass Boost: 0 - 6 dB
• Fuse Rating: 80A
• 4 AWG gauge amplifier wiring kit is recommended for installation
• Dimensions: 9-3/4" L x 4-1/2" W x 1-7/8" H
• UK Internet Dealer
• Full Manufacturer's Warranty

What's in the Box

• Mono powersports amplifier (attached 10" wiring harness)
• 2 Power/ground wire couplers
• Four 1" screws
• Logo badge with adhesive backing
• Instruction sheet