Kicker 48KXMA900.5 900W RMS KM Series 2-ohm Stable 8 Channel Class-D Marine Amplifier

Dependable power for your boat's sound system

Want one amplifier to run your boat's entire audio system? Kicker's KXMA900.5 marine 5-channel amp can power four speakers with 75 watts RMS each while driving a subwoofer with up to 400 watts RMS. This reliable and compact KXMA Series rocker remains cool even when pushed hard, thanks to its high-mass heatsink, high-tech internal components, and efficient full-range Class-D amp technology. If you're looking for louder or have some demanding speakers, you could also use this amp in 3-channel mode to send 250 watts RMS each to some high-performance components, and with 400 watts going to the sub.

3-way system

The KXMA900.5 will also work well powering a 3-way system, with the Amp 1 channels running the tweeters, Amp 2 the woofers, and the Sub-channel taking care of a subwoofer or two.

Made for marine use

This rugged amp features a conformal-coated circuit board for improved water and dust resistance, plus corrosion-resistant power connections, a gasket-sealed front cover, and stainless steel mounting hardware that won't rust all over your boat's gel coat or carpeting.

Connection perfection

Kicker employs their Fail-Safe Integration Technology (FIT2™) to reject noise and stop any interference generated by your boat's electronics, so you'll enjoy your music clean and pure. Speaker-level inputs make it possible to hook this amp up to almost any receiver or radio. Kicker also helps you set this amp's gain properly, by offering free test tones for downloading. You play a tone and turn the gain up until the gain knob glows red. Then, you turn it down until it just goes out, and the amp's gain is set perfectly. Kicker also includes a wired remote bass knob when you need to turn up the thump from the driver's seat. 

Versatile controls behind the folding door

A gasket-sealed front door gives you quick and easy access to your amp's controls. You can tune for almost any kind of speaker, as the steeply-sloped high- and low-pass filters offer a wide range of adjustments. The filter section for the rear channels can be set up for bandpass operation — where both the high- and low-pass filters are engaged to allow only the frequencies between them to play — for optimizing the signal for midrange speakers in a 3-way system.

The subwoofer channel includes a bass boost for adding some kick to your music, along with a subsonic filter that eliminates the extra-low, inaudible frequencies that only waste your sub's energy.

KXMA900.5 control panel

Product Features:

• Kicker KXM Series KXMA900.5 (48KXMA9005)
• Class-D 1-Ohm Stable (Sub Ch) 5-Channel Amplifier
• RMS Power Rating:
• 4 ohms: 50 watts x 4 chan.
• 2 ohms: 100 watts x 4 chan.
• Bridged, 4 ohms: 200 watts x 2 chan
• Subwoofer Channel Power Rating:
• 4 ohms: 200 watts x 1 chan.
• 2 ohms: 400 watts x 1 chan.
• 1 ohm: 400 watts x 1 chan.
• Subwoofer Channel Power Rating:
• CEA-2006 Compliant Amplifier
• Pulse Width Modulated MOSFET power supply
• KXARC Wireless Remote Included
• Speaker-level (high-level) inputs: requires, sold separately
• Gain Control With Optimal Input Indicator
• SHOCwave™ Bass Restoration Processor
• FIT2 (Fail-Safe Integration Technology) Circuitry
• DSP-Controlled Preamp
• ABYC/NMMA Compliant Power Terminals
• Conformal-Coated Circuit Boards
• Easy Access to Settings behind Gasket-Sealed Cover Panel
• Black Anodized Aluminum Chassis
• Stainless Steel Mounting Hardware Included
• LED power (green) and protect (red) indicators
• Soft start turn-on
• 3-way protection circuitry (thermal, overload, and speaker short protection)
• Dual speaker terminals simplify the hookup of multiple speakers
• Heavy-duty aluminum alloy heat-sink for extreme heat dissipation
• Input sensitivity: 250mV - 10V
• Frequency Response: 10 - 160 Hz
• Total Harmonic Distortion (THD) 1%
• Signal to Noise Ratio: 95dB
• Selectable crossover mode (front/rear): Off / HP / LP , BP (Rear Only)
• x1 & x10 Frequency Multiplier, Front & Rear
• Variable crossover filter (Front): 10 - 500 Hz, 24 dB/octave
• Variable high-pass filter (Rear): 10 - 500 Hz, 24 dB/octave
• Variable low-pass filter (Rear): 40 - 500 Hz, 24 dB/octave
• Variable low-pass filter (Sub): 40 - 160 Hz, 24 dB/octave
• Subsonic filter: 10 - 80 Hz , 24 dB/octave
• Fuse Rating: 100A x 1 External Fuse (sold separately)
• 4 gauge power and ground wiring is recommended for installation. 
• Dimensions: 8-5/16"W x 9-9/16"L x 2-1/8"H
• UK Internet Dealer
• 1-year Manufacturer's Warranty

What's in the box:

• 5-Channel marine amplifier
• KMBLC Remote bass level control
• 19.5' Remote cable (RJ-11 connectors on both ends)
• Two 3/8" screws
• Four 2" screws
• 4 Flat-washers
• 3mm Allen key
• Amplifier information sheet (Eng/Span/Fren/Ger)
• Power chart
• Kicker power certification

Product history:

	Kicker KXMA900.5 (48KXMA9005) (newest, current model)
	Kicker KXMA800.5 (44KXMA8005) (previous model, replaced by Kicker KXMA900.5 (48KXMA9005))
	Kicker KXM800.5 (40KXM800.5) (previous model, replaced by Kicker KXMA800.5 (44KXMA8005))