JL Audio XD1000/5v2 - XDv2 Series 5-Channel Class D System Amplifier

This one amp will power your entire system

XD1000/5v2 connection and control panels

JL Audio's XD1000/5v2 amp packs a wallop far beyond what you'd expect from something so small. This compact amp plays your music with true fidelity and impressive impact, without straining your car's electrical system. A cast alloy heatsink and an advanced cooling system keep this amp at the optimal temperature, eliminating thermal shut-downs so your music keeps going strong without interruption.

This 5-channel amp can power your vehicle's entire system, delivering 75 watts RMS to each of your front and rear speakers, while powering a sub with up to 600 watts. You can also switch to 3-channel mode, and power a pair of high-performance speakers with 200 watts each, while still driving a sub with 600 watts.

High- and low-pass filters give you intimate control over the character of your sound. "Differential-balanced" inputs keep the signals clear of outside noise and allow you to connect this amp to just about any in-dash stereo, even a factory radio with no preamp outputs. An optional wired remote lets you tweak the level of the subwoofer or the whole system from your front seat.

XD1000/5v2 control panel

• XDv2 Series Class D 5-Channel Amplifier
• RMS Power Rating @14.4V: Channel 1 - 4
• 4 ohms: 75 watts x 4 chan.
• 2 ohms: 100 watts x 4 chan.
• Bridged 4 ohms: 200 watts x 2 chan.
• RMS Power Rating @14.4V: Sub Channel
• 4 ohms: 400 watts x 1 chan.
• 3 ohms: 500 watts x 1 chan.
• 2 ohms: 600 watts x 1 chan.
• RMS Power Rating @12.5V: Channel 1 - 4
• 4 ohms: 60 watts x 4 chan.
• 2 ohms: 90 watts x 4 chan.
• Bridged 4 ohms: 180 watts x 2 chan.
• RMS Power Rating @12.5V: Sub Channel
• 4 ohms: 360 watts x 1 chan.
• 3 ohms: 180 watts x 1 chan.
• 2 ohms: 600 watts x 1 chan.
• NexD High-Speed Switching Class D Technology
• Wired HD-RLC remote level control available, sold separately
• LED power (green), over-current (yellow) and protect (red) indicators
• Advanced Rollback Protection
• Differential Balanced Input Section
• Selectable turn-on modes: REM / Offset / Signal
• +12 V Remote Turn-On: Traditional remote lead wire, from headunit
• DC Offset-Sensing: On/Off by detecting a very small DC signal (high-level signal only)
• Signal-Sensing: On/Off by detecting a full-range audio signal at left-channel input (high-level signal only)
• Speaker level inputs via RCA, JL Audio XD-CLRAIC2-SW required
• Heavy-duty aluminum alloy heat-sink for extreme heat dissipation
• 3-way protection circuitry (thermal, overload, and speaker short protection)
• Detented, Calibrated Filter Freq. Potentiometer
• Input mode selectable: 2 Ch. / 4 Ch. / 6 Ch.
• 12 dB/octave Butterworth or 24 dB/octave Linkwitz-Riley Crossover
• Selectable Low-Pass Filter Slope (Sub Ch): 12 dB or 24 dB
• Variable low-pass filter: 50 - 500 Hz, 12 or 24 dB/octave
• Selectable HP filter mode (Ch 1/2): Off / x1 / x10
• Selectable filter mode (Ch 3/4): Off / BP/ HPInput sensitivity:
• • Low level: 800mV - 8V
  • High level: 200mV - 2V
• Frequency Response (Ch 1-4): 12 - 22,000 Hz
• Frequency Response (Sub Ch): 10 - 1,000 Hz
• Total Harmonic Distortion (THD): <1%
• Signal to Noise Ratio: >104 dB
• Damping Factor @4ohms: >150 / 50 Hz
• Fuse Rating: 80A x 1 inline (not supplied)
• 4 gauge power and ground wiring is recommended for installation. 
• Weight: 9.00 lb
• Dimensions: 7.09"W x 14.73"L x 2.05"H
• UK Internet Dealer
• 1 Year Manufacturer's Warranty

What's in the box: