A kilowatt for your sub
XD1000/1v2 inputs and filter section
JL Audio's XD1000/1v2 amp packs a wallop far beyond what you'd expect from something so small. This amp plays bass with true fidelity and impressive impact, without straining your car's electrical system. A cast alloy heatsink and an advanced cooling system keep this amp at the optimal temperature, eliminating thermal shut-downs so your music keeps going strong without interruption.
The XD1000/1v2 mono amp delivers up to 1000 watts RMS to your subwoofer system, and its low-pass filter features a choice of slopes for better control over the character of your bass. A subsonic filter allows you to tighten up your system's kick and gets rid of any inaudible, low-frequency information that could detract from your sub's performance.
"Differential-balanced" inputs keep the signals clear of outside noise and allow you to connect this amp to just about any in-dash stereo, even a factory radio with no preamp outputs. An optional wired remote lets you tweak your bass level from your front seat.
XD1000/1v2 control panel
Product Features:
- XDv2 Series Class D Monoblock Amplifier
- RMS Power Rating @14.4V:
- 4 ohms: 600 watts x 1 chan.
- 3 ohms: 800 watts x 1 chan.
- 2 ohms: 1000 watts x 1 chan.
- 1 ohm: ----------N/A----------
- RMS Power Rating @12.5V:
- 4 ohms: 500 watts x 1 chan.
- 3 ohms: 650 watts x 1 chan.
- 2 ohms: 800 watts x 1 chan.
- 1 ohm: ----------N/A----------
- NexD High Speed Switching Class D Technology
- Wired HD-RLC remote level control available, sold separately
- LED power (green), over-current (yellow) and protect (red) indicators
- Advanced Rollback Protection
- Dual-Range Differential Balanced Input Section
- Buffered pass-through preamp RCA outputs
- Selectable turn-on modes: REM / Offset / Signal
- +12 V Remote Turn-On: Traditional remote lead wire, from headunit
- DC Offset-Sensing: On/Off by detecting a very small DC signal (high-level signal only)
- Signal-Sensing: On/Off by detecting a full-range audio signal at left-channel input (high-level signal only)
- Speaker level inputs via RCA, JL Audio XD-CLRAIC2-SW required
- Dual speaker terminals simplify the hookup of multiple speakers
- Heavy duty aluminum alloy heat-sink for extreme heat dissipation
- 3-way protection circuitry (thermal, overload, and speaker short protection)
- Detented, Calibrated Filter Freq. Potentiometer
- 12 dB/octave Butterworth or 24 dB/octave Linkwitz-Riley Crossover
- Input sensitivity:
- Low level: 800mV - 8V
- High level: 200mV - 2V
- Frequency Response: 7 - 500 Hz
- Total Harmonic Distortion (THD): <1%
- Signal to Noise Ratio: >83 dB
- Damping Factor @ 4 ohms: >1000 / 50 Hz
- Selectable Infrasonic Filter: Off / 30 Hz
- Selectable Low-Pass Filter Slope: 12 dB or 24 dB
- Variable low-pass filter: 50 - 500 Hz, 12 or 24 dB/octave
- Fuse Rating: 80A x 1 inline (not supplied)
- 4 gauge power and ground wiring is recommended for installation.
- Weight: 8.50 lb
- Dimensions: 7.09"W x 14.73"L x 2.05"H
- UK Internet Dealer
- Manufacturer's Warranty
Price | £649.99 |
---|---|
Manufacturer | JL Audio |
Vehicle Manufacturer | None |