Small footprint, big kick
JL Audio's M200/2 marine amplifier is small — less than 7" wide — but it delivers a massive amount of power from its compact chassis — up to 100 watts from its two channels. It owes these impressive specs to JL Audio's Class D NexD™ ultra-high-speed switching design, which eliminates the traditional drawbacks of a Class D amp design to deliver full-bandwidth performance, excellent efficiency, and very low distortion levels.
Great for a variety of applications
You can use this 2-channel amp for a variety of applications. It's great for kicking up the power to a pair of high-performance coaxial or component speakers, or you can bridge the amp to a single channel to drive a sub. You can run the built-in variable frequency filters in high- or low-pass mode, depending on whether you're powering speakers or subs.
A set of preamp outputs makes it easier to get signal to another amplifier in your system. The special powder-coat finishes, the gasketed control cover, and the stainless-steel hardware all protect this amp against the harsh realities of the marine environment.
Product Features:
- M Series 2-Channel Class D Full-Range Amplifier
- RMS Power Rating @14.4V:
- RMS Power Rating @12.5V:
- RMS Power Rating @12.5V:
- NexD High-Speed Switching Class D Technology
- Wired HD-RLC remote level control available, sold separately
- White and gray powder-coat finishes
- Gasketed cover over controls
- Stainless steel hardware
- LED power (green), over-current (yellow) and protect (red) indicators
- Advanced Rollback Protection
- Differential Balanced RCA Input
- Pass-through preamp RCA outputs
- Heavy-duty aluminum alloy heat-sink for extreme heat dissipation
- 3-way protection circuitry (thermal, overload, and speaker short protection)
- Detented, Calibrated Filter Freq. Potentiometer
- State-variable, 12dB/octave Butterworth Crossover
- Input sensitivity: High level: 100mV - 4V
- Frequency Response: 12 - 22,000 Hz
- Total Harmonic Distortion (THD): <1%
- Signal to Noise Ratio: >104 dB
- Damping Factor @4 ohms: >150 / 50 Hz
- Selectable Filter Mode: Off / HP / LP
- Variable low-pass filter: 50 - 500 Hz, 12 dB/octave
- Fuse Rating: 20A x 1 inline (not supplied)
- 4 - 8 gauge power and ground wiring is recommended for installation.
- Weight: 4.20 lb
- Dimensions: 7.09"W x 6.85"L x 2.05"H
- UK Internet Dealer
- 1-year Manufacturer's Warranty
What's in the box:
- 2-Channel Class-D marine amplifier
- 2.5mm Allen wrench
- JL Audio emblem
- Owner's Manual
Price | £339.99 |
---|---|
Manufacturer | JL Audio |
Vehicle Manufacturer | None |