YOU MAY NEED
SEE OTHER PRODUCTS BY HELIX
HELIX P ONE
ELEMENTAL FORCE WITH MAXIMUM CONTROL
The new P ONE will drive every subwoofer to the absolute maximum, since it delivers relentless power with 1,500 Watts RMS power into 1 Ohm. Its phenomenal stability predestines the P ONE as the ideal driver for any subwoofer configuration you can imagine and its enormous damping factor keeps every loudspeaker under full control. If that's still not enough, you can use the TwinPower Link to combine two amplifiers and double the output power.
HIGH-RES AUDIO
Even though the P ONE will drive subwoofers in most cases, it can also be used as an "almighty" fullrange amplifier thanks to its wide frequency range up to 40 kHz, the extremely low THD and the excellent signal-to-noise ratio.
HIGHEST POWER DENSITY EVER FROM AUDIOTEC FISCHER
This power pack also sets new standards in other respects as never before so much power has been accommodated in such a compact housing for easiest installation. The unique "power-to-size" ratio is the result of the extraordinary efficiency of our Class D concept, which goes hand in hand with exceptionally low heat dissipation. A unique effort has also been made with the protective circuits which are particularly important in this power segment. For the first time, a microprocessor-controlled Hall effect current sensor continuously monitors the total power consumption of the amplifier in order to enable the maximum output power under all conditions.
FULLY DIGITAL SIGNAL CHAIN
Finally, the P ONE can be upgraded with our optional HDM 1 module that offers an optical input, means digital audio signals can be losslessly and directly processed. That's how you get the very last bit of performance out of this stunning amplifier.
FEATURES
- High performance Class D mono amplifier with up to 1,500 Watts RMS @ 1 Ohm – a perfect match for all 2 x 2 Ohms subwoofers connected in parallel
- Also usable as an ultra broadband amplifier with exceptional sound quality – ideal for High Resolution Audio
- Extremely high efficiency and low heat dissipation with minimal dimensions
- High damping factor for maximum speaker control
- Regulated power supply with Start-Stop capability for extremely stable output power even during voltage drops
- TwinPower Link for connecting two amplifiers in bridged mode
- Optionally available HELIX Digital Input Module (HDM) to extend the amplifier with an optical digital input in SPDIF format
Product Features:
- Power RMS ≤ 1% THD+N
- - @ 4 Ohms: 1 x 500 Watts
- - @ 2 Ohms: 1 x 880 Watts
- - @ 1 Ohm: 1 x 1,500 Watts
- Max. output power per channel*: Up to 1.800 Watts RMS @ 1 Ohms
- Amplifier technology: Class D
- Inputs: 2 x RCA / Cinch, 1 x Remote In, 1 x Optical SPDIF (28 - 96 kHz)
- Input sensitivity: RCA / Cinch 0.5 - 8 Volts
- Input impedance RCA / Cinch: 20 kOhms
- Outputs: 1 x Speaker output
- Signal converter for digital input: BurrBrown 32 Bit DA converter
- Frequency response: 21 Hz - 40,000 Hz
- Subsonic: 21 Hz
- Slope subsonic / lowpass: Butterworth 48 dB/Oct.
- Signal-to-noise ratio digital input: 110 dB (A-weighted)
- Signal-to-noise ratio analog input: 110 dB (A-weighted)
- Distortion (THD): < 0.01 %
- Damping factor: > 450
- Operating voltage: 10.5 - 17 Volts (max. 5 sec. down to 6 Volts)
- Idle current: 1500 mA
- Fuse: 4 x 30 A LP-Mini-fuse (APS)
- Power rating: DC 12 V ⎓ 160 A max.
- Additional features: Input mode switch, SPDIF Direct In switch, Start-Stop capability
- Dimensions (H x W x D): 50 x 260 x 190 mm / 1.97 x 10.24 x 7.48”
| Price | £899.99 |
|---|---|
| Manufacturer | HELIX |
| Vehicle Manufacturer | None |
SEE OTHER PRODUCTS BY HELIX